Using INCLAN control statements

From CYANA Wiki
Revision as of 14:18, 7 January 2010 by Guentert (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

INCLAN provides a full set of control statements to direct the program flow. These are used mainly in macros, i. e. in collections of INCLAN statements that form new commands which can be used in the same way as basic commands. Since control statements are not used interactively, the program prompt (“cyana>”) will no longer be shown.

Commands can be executed conditionally by virtue of the “if” statement which has the same form as in Fortran:

if (i.gt.20) print "i is larger than 20."
if (i.lt.0) then
  print "i is negative."
else if (i.lt.10 .and. mod(i,2).eq.0) then
  print "i is less than 10 and even."
else
  print "i is none of the above."
end if

Alternatively, comparison and logical operators can also be given in the form of the C programming language:

if (i>20) print "i is larger than 20."
if (i<0) then
  print "i is negative."
else if (i<10 && mod(i,2)==0) then
  print "i is less than 10 and even."
else
  print "i is none of the above."
end if

Note, however, that expressions are always evaluated according to the rules of Fortran-77. Repeated execution of commands is achieved by forming loops with the “do” statement. Loops executed a predefined number of times have an integer loop variable:

do i 1 20
  print "i = $i"
end do

Here, the loop variable, i, runs from 1 to 20 in steps of 1. A loop that is executed until a termination condition is met can be constructed as follows:

do
  ...
  if (x.gt.100.0 .or. finished) break
  ...
end do

The “break” statement exits from a loop. Unconditional jumps are possible with the “go to” statement:

do i 1 n 
  ...
  if (err) go to cleanup
  ...
end do
...
cleanup: print "Error in the loop."
...

The “go to” statement transfers the program flow to the position indicated by the label (“cleanup”).